Put these wheels on a S10 Blazer LS swap. Chose the "B" face rear to match the fronts. I did have to use a 1" spacer to get the tire/wheel offset to match the front to line up with the fenders. Fit a 285/40/18 Firestone on them and was perfect fit. Only worry i have is it seems that this style is going out of stock everywhere, so hopefully its not going to be discontinued(9/24/26)...

0 of 0 found this review helpful.

Was this review helpful? 0 0

Report

I originally ordered 4 wheels direct from Holley. They shipped 3 with the 4th being on backorder. Since they missed their new ship date, I ordered from Summit since it was in stock. This particular wheel is the one that almost fell off my car twice within about 15 miles. Gorilla branded lug nuts on Moser 1/2" studs with the correct 100 ft-lb torque, which I am a fanatic about maintaining. Since I still have 3 good ones, I made the decision to order a replacement wheel for this one as I am not comfortable driving on it. Also have to pull the axle and replace wheel studs again.

0 of 0 found this review helpful.

Was this review helpful? 0 0

Report

Wheels are for a 3rd Gen IROC Camaro. I purchased 18x10s for the rear and 18x9s for the front. First off, don't get too excited when you get the boxes and the back space listed on the box doesn't match what you ordered. The part number is correct on the box but not the back space number. The wheels measured correctly as stated in Summit description. All the wheels looked great with no damaged from shipping and no manufacturing defects that I could see. If you have an older car like me, with long front spindles, you may as well order the new center caps with extra clearance immediately as the included flush caps won't clear the hub or bearing cover. I got them on sale directly from Rocket Racing and they still were over $100 for a set. Even with extra clearance center caps, they won't fit the front as is. The I.D. of the center cap is too small to fit over the bearing cover or the end of the hub itself. I think this can be solved, but I will need to modify the end of the hub. I may need to have it machined along with the center cap to clear.

0 of 0 found this review helpful.

Was this review helpful? 0 0

Report