Ignition System & Kits

Dynatek Dyna 2KI Programmable Ignitions

Dyna 2Ki Programmable Ignitions not only add to, but extend, many features of the Dyna 2000 modules with a completely new design that fits under the cam cover. Every time power to the ignition is switched on, the 2Ki checks to see if the coil is shorted, mis-wired, or of the wrong type. If an error is detected, the 2Ki will immediately switch off and issue a warning. After starting, the 2Ki continuously monitors the status of the coil and wiring. All 2Ki ignitions are PC programmable: * 8-point fully-definable wide-open throttle curve * 8-point fully-definable part-throttle curve * Rev limit programmable in 50 rpm steps * Programmable dead cranking revs 0-10 * Programmable rear cylinder offset, total of +/- 10 degrees Data recording functions: * Total engine hours * Time at wide-open throttle * Number of engine starts * Longest time operating at wide-open throttle * Maximum rpm * Seconds near rev limit * Statistical analysis of time at rpm Additional features and benefits include: * Single-fire operation down to zero rpm for easier cranking and kicking * Operates in all combinations of single-fire or dual-fire with single plug or dual plug heads (when used with appropriate coils) * Eight advance curves to cover a broad range of engine builds and riding styles * Over-rev protection adjustable from 6000 to 7500 rpm * Adjustable timing retard for nitrous and turbo applications * VOES indicator; shows the status of the VOES switch, also indicates when retard mode is active * Built-in tach driver delivers stable tach signal even during rev limiting; can be used to activate shift lights, auto shifters, and other accessories * Easy static timing with built-in timing indicator (no timing light required) * Intelligent over-current and short circuit protection * Active dwell control continually adjusts coil current to maintain maximum spark energy up to redline while eliminating coil stress caused by overcharging at idle * High-efficiency design reduces battery draw for easier cold weather starting and lower charging system load * Ruggedized output--cannot be damaged by broken or disconnected spark plug wires * Over-voltage protected against momentary spikes (positive and negative) as well as surges caused by faulty voltage regulators or quick-charge battery boosters * Harness constructed with TXL cross-linked polyethylene automotive wire for exceptional resistance to abrasion, heat, and chemical attack * High-temp glass-braid jacket further increases the toughness of the harness and provides a tight, clean appearance * Wire colors closely match the factory harness for error-free installation * Manufactured with premium-quality components designed for operation in a high-temperature, high-vibration environment * One-piece aluminum housing and thermally-conductive epoxy encapsulation provide superior heat dissipation and outstanding shock, vibration, and moisture resistance * Advanced microprocessor technology * Quartz crystal accuracy.

Not Yet Reviewed