Availability
Showing In Stock Items. Show All 6 Items.
On Sale
AEM 22-channel CAN sensor modules provide a way for users with carbureted vehicles to add an AEM CD digital dash display. They also let users with existing CAN-based devices add more channels to the display for viewing and/or data logging. These 22-channel modules convert analog, digital, and frequency inputs into an AEMnet CAN bus signal that can be transmitted to AEM's CD-5 carbon and CD-7 digital dashes. AEM Electronics 22-channel CAN sensor module includes: * Wiring harness with 36 in. flying leads and pre-wired CAN cable * IP65-rated enclosure is dust-tight and water-resistant * Daisy-chain two modules together for additional channels (modules sold individually) * Four dedicated 0-5 V analog inputs * Four temperature (thermistor) inputs * Four user-configurable inputs for 0-5 V, temp (including RTD) * One dedicated fuel level input (0 to 250 ohm range) * Six digital inputs, active low, protected to about 18 V, frequency, duty cycle or simple switch * One tach input, trigger when low, 12 V internal pull up * Two VR pair frequency inputs (crank, wheel, or driveshaft speeds) * Jumper selectable CAN bus speeds, 250k, 500k, 1M * Jumper selectable terminating resistor * Jumper selectable header length, 11 bit or 29 bit
Not Yet Reviewed
$413.95
$371.95
On Sale
AEM exhaust backpressure install kits are specifically designed to give accurate backpressure readings, without sacrificing sensor longevity due to extreme operating conditions. Designed for use with their 4-channel wideband UEGO controller, you get precision readings for ultimate performance using AEM exhaust backpressure install kits. Kits include: * Stainless steel 100 psig pressure sensor * Stainless steel standoff tube with fittings * Stainless steel braided hose * Weld-on/threaded bung.
( 1 )
$368.95
$332.05
Manufacturer Rebate
AutoMeter CAN Bridge data modules are the ideal solution to streamline adding gauges or an InVision LCD dash to OBDII based engine and vehicle platforms (2008+). The intuitive CAN Bridge simply plugs into the diagnostic port and captures the existing sensor data and outputs up to six signals to drive a tachometer, speedometer, temperature, pressure, fuel level (0-90 ohm only), and volts on your vehicle. Quickly and easily setup your system to output the available parameters of your choice by utilizing the CAN Bridge data module's menu navigation buttons and OLED display. With this advanced CAN Bridge system from AutoMeter, you can now simplify your next instrumentation installation on your ride! Additional features: * Works with most OBD-II applications which is standardized across all OEMs starting in 2008 * Module includes OLED display and five push buttons to effortlessly navigate menus and program system for operation * Plug-and-play from OBDII to traditional round AutoMeter short sweep electric gauges, tachometers, electronic speedometers, and InVision LCD dashes * Six total channels available: tachometer, speedometer, fuel level (0-90 ohm only), temp, pressure, and volts * Simplifies instrumentation wiring and installation; no sensors to hookup, which means less wires to connect * Sensor data must be present on the data stream to function, otherwise a discrete sensor must be used
Not Yet Reviewed
$363.99
Modal Header
Truck / SUV
Jeep®
Restoration
Stock Replacement
Late Model Muscle
Tools
Gifts, Clothing, & More
Circle Track
Street Rod
Powersports
Paint & Body
Marine
Jr Dragster
