Availability
Summit Racing™ high-output 4-pin HEI performance modules feature a longer dwell time for better coil saturation. This equates to a hotter spark and better performance for your HEI setup.
( 13 )
$55.99
If your ignition module dies, you won't be going anywhere, and you have things to do and places to go. You can keep your distributor running smoothly with replacement ignition modules from Summit Racing™. These direct-replacement simple 3-wire hookups will have you out and about in no time. Make sure you're always ready with Summit Racing™ replacement ignition modules.
( 30 )
$35.99
—
$78.99
Summit Racing™ offers GM high-energy modules with rev limiters that enable you to adjust the rpm limit from 5,000 to 9,500 rpm. They are high performance modules built for HEI distributors, producing 50 percent higher coil drive currents than the stock module. This saturates the coil faster, delivering more spark energy at top speeds. Your benefits are increased horsepower and rpm range, plus improved starting. GM HEI modules replace all 4-pin modules used in HEI distributors with a vacuum advance canister. They can be used with factory or aftermarket HEI distributors.
( 4 )
$130.99
Summit Racing™ ignition module conversion kits are used on GM vehicles equipped with 5-pin HEI ignition modules. If you feel a hesitation or stall on deceleration, install one of our Summit Racing™ ignition module conversion kits today!
Not Yet Reviewed
$7.99
These Summit Racing™ GM HEI ignition tune-up kits offer an affordable way to bring your stock GM HEI distributor back to life. They include the following components: * High-power 50,000 V HEI coil * Distributor cap and rotor * Coil dust cover * Low-saturation ignition control module * Adjustable vacuum advance unit * HEI bushing (between the coil and cap) * Wiring harness and capacitor * High performance advance spring and weight set * Mounting hardware
( 163 )
$81.99
—
$83.99
We've taken our original Ready-to-Run billet distributors and upped the ante with our Summit Racing™ Digital RTR (Ready-to-Run) Plus billet distributors. They now feature a digital module with a 7.5 amp rated dwell control circuit for maximum energy output. They deliver 400 volts and 125mJ of spark energy to the coil and upwards of 50,000 volts from the coil to the spark plugs. We've also added a single-stage rev limiter with a simple "tap to ground" process of the tachometer lead attached to the module to set the limiter. The tachometer dual purpose lead also produces a 25 percent duty cycle, square wave signal, so it can be used with multifunction tachometers and most popular aftermarket EFI systems. Another bonus feature of our digital technology is a fully automatic start retard. This built-in feature provides 4 degrees of timing retard during cranking and is fully dialed out by 300 rpm. This gives you easier and quicker hot restarts while lowering the initial start load on the starter and electrical system. With all these upgraded features, you're assured of peak output throughout all RPM ranges, quicker hot starts, EFI capability and the reliability of digital technology. The distributors still have the same lightweight, forged, precision CNC-machined aluminum housing for strength and stability; polished steel shafts with sealed ball bearings for stable operation through 10,000 rpm; and a maintenance-free, high-output magnetic trigger for accurate and reliable performance. All distributors come with a high-quality, 30 percent glass-filled PBT cap and rotor with brass terminals and contacts. An ignition box is not required for use with Summit Racing™ Digital RTR Plus billet distributors except when used with an aftermarket EFI system. Select the model recommended for your car, truck, or van.
( 3 )
$299.99
—
$499.99
Summit Racing™ ignition controllers will increase your ignition capability and energy. These OEM-style controllers come in both 5,500 rpm and 6,800 rpm versions to best fit your application and work with all popular Chrysler engines.
( 25 )
$31.99
—
$43.99
Summit Racing™ offers reproduction wiring harnesses for a wide selection of vehicles, particularly classic cars and trucks from the 1960s and '70s. These replacements and/or extensions are used to power a variety of applications—including horn, glove box, console, backup lights, engine; forward, hood, and courtesy lamps; fuel tank sender, and more. These OE style replacement harnesses are made of high-quality Automotive Grade Wire using factory style fuse blocks, plug ends, and wire colors to ensure factory type fit, performance, and durability. For repair or restoration, order the harness recommended for your specific car or truck. Note: These harnesses are factory replacements and do not include instructions or wiring diagrams refer to the factory diagrams and or service manuals for your specific vehicle.
( 49 )
$27.99
—
$458.99
On Sale
Summit Racing™ offers ignition tune-up kit Pro Packs for countless vehicles from the 1950s and up. Depending on your application, the kits may include a distributor, ignition coil, spark plugs and wires, ignition box and module, rotor, and many other options. Get the most from your ignition and engine; choose the ignition tune-up kit Pro Pack recommended for your car or truck.
( 51 )
$502.87
$160.89
—
$1,025.54
Summit Racing™ billet electronic Mopar distributors convert your old points ignition to a new modern electronic breaker-less system. Available as standalone units or in a complete kit, these distributors offer these benefits: improved timing and dwell control; higher energy at the spark plug for easier starting; improved throttle response; extended RPM range; and better efficiency, along with increased spark plug life. The distributor bodies are CNC-machined from forged 6061-T6 aircraft-grade aluminum and come with a glass fiber reinforced (PBT) tan cap (which is patterned after the OEM dual point cap)—with extra internal voltage dams that help to prevent crossfire while resisting carbon tracking. The shafts are centerless ground and ride on both upper and lower sealed roller bearings for smooth operation at high RPM's and extended service life. The cap contacts and rotor blade are brass and the rotor spring is stainless steel, all for long-term maximum conductivity. Kits include the orange 6,500 rpm ignition control module, an advance curve kit, wire harness, ballast resistor, performance oil-filled ignition coil, and installation hardware kit. Order the model recommended for your vehicle.
( 59 )
$194.99
—
$239.99
Summit Racing™ Electronic Distributor Conversion kits allow you to Convert your factory single point distributor to a true 1 wire solid state ignition. Simply remove and replace your points and condenser with the solid state breakerless ignition module. Simple stealth 1 wire hookup is perfect for 100 point type restorations as it is undetectable. Never deal with breakdowns or adjusting worn or burned points again with a Summit Racing™ Electronic Distributor Conversion kit. • 1 Wire Hook-Up, just connect to the original points wire • Completely stock appearing • Fits inside 57-74 Delco Window cap distributors • Auto-standby prevents coil damage or dead battery if the ignition is accidentally left on • Active dwell control maintains high rpm spark energy while reducing coil heating at idle. • Hall effect rotary-vane sensor design compensates for worn bearings and distributor end play. • Magnetic sensor is unaffected by oil, dirt or other contaminants, unlike optical systems. • Over-voltage/over-current protected against damage from high amp battery chargers, reversed battery, or improper wiring • No distributor modification, disassembly, or removal is required , use SUM-RP20594 For New Repl. Black Ground Wire To Finish The Conversion.
( 10 )
$167.99
Revitalize your small block Chevy's ignition with our Summit Racing™ ignition kits. These packages includes a Summit blueprinted HEI distributor with a powerful 50,000V coil, a high-output 5.7 amp module for precise timing, and a hardened iron drive gear suitable for use with a flat tappet camshaft. Plus, a set of custom-fit Summit 8mm ignition wires, which have a spiral-wound 270 ohm/ft. conductor around an aramid fiber core, blue silicone outer jackets, and stainless steel and brass terminals.
( 18 )
$150.98
Losing those little RPM modules can be a hassle, but now you can lose them all permanently. Our Summit Racing™ RPM-activated switches allow you to select an activation level anywhere from 1,000 to 9,900 rpm in increments of 100 rpm; and they work with 4, 6, and 8-cylinder engines. The switches will activate or deactivate via several trigger sources. Detailed instructions are included for rpm activation the easy way.
( 12 )
$54.99
Summit Racing™ Mopar electronic coil with ballast resistor kits are specifically designed as a direct-replacement for Chrysler electronic ignition systems using a 4-pin Chrysler module only. When these coils are coupled with the ballast resistor, they move the primary resistance from .70 ohms to 2.0 to 2.25 ohms, giving your Mopar electronic ignition system the spark it needs to let your motor make the horsepower it was intended to make!
Not Yet Reviewed
$44.99
Voltage spikes are generally associated with "noisy" electrical systems from defects such as worn or dirty alternator brushes, corroded or oxidized connections, and similar electrical problems. Summit Racing™ power filters offer a great solution to those issues. These units are for use with Unilite ignition systems, and are designed to absorb electrical spikes from the ignition—thus saving the electric module inside the distributor. They connect between the distributor female connector and distributor wire harness male connector, easily attaching with Velcro®.
( 8 )
$50.99
This compact dimmer module is designed to allow for isolated dimming for Summit stepper motor gauges separate from your vehicle's OEM dash. This dimmer module will dim up to 7 gauges.
( 4 )
$39.99
Get more power from a high-energy ignition than you ever expected with a brand new Summit Racing™ blueprinted HEI distributor. They feature a 50,000 V coil, medium weight advance springs, and an aluminum housing. The distributor shafts are guided by precisely aligned bushings for durability in extended street use, and most models include an adjustable vacuum advance. Separate advance springs are available, so you can fine-tune to your hearts content. Be in it to win it—with the Summit Racing™ blueprinted HEI distributor designed to fit your application.
( 1223 )
$112.99
—
$399.99
Replace your stock LT1 Optispark distributor with our all-new Summit Racing™ LT1 Optispark I or II distributors. These distributors feature an aluminum housing with heavy-duty oilite bushings, and a glass-reinforced cap with high dielectric strength and aluminum terminals.
( 121 )
$240.99
—
$261.99
On Sale
Our Summit Racing™ Ready-to-Run billet distributors provide reliable spark throughout the rpm range, so they'll deliver the performance you need, no matter what you drive--race car, street machine, or hauler. The affordable distributors have high-dollar features that outperform the competition, like a lightweight aluminum housing that's precision CNC-machined for strength and stability, polished steel shafts with sealed ball bearings for stable operation through 10,000 rpm, and a maintenance-free, high-output magnetic trigger for accurate and reliable performance. The distributors have a black alkyd cap and some models also feature vacuum advance. An ignition box is not required for use with Summit Racing™ Ready-to-Run billet distributors except when used with an aftermarket EFI system.
( 22 )
$277.99
$250.19
—
$359.99
Our Summit Racing™ computer-controlled billet distributors provide reliable spark throughout the rpm range, so they'll deliver the performance you need, no matter what you drive--race car, street machine, or hauler. The affordable distributors have high-dollar features that outperform the competition, like a lightweight aluminum housing that's precision CNC-machined for strength and stability, polished steel shafts with sealed ball bearings for stable operation through 10,000 rpm, and a maintenance-free, high-output magnetic trigger for accurate and reliable performance.
( 93 )
$219.99
—
$304.99
Summit Racing™ billet aluminum marine distributors are designed as direct replacements for marine applications. The distributors feature an aluminum housing and meet or exceed SAE J1171 standards. When you need a replacement distributor to get your ignition system back to working as it should, you can trust a Summit Racing™ billet aluminum marine distributor.
Not Yet Reviewed
$335.99
Replace your tired stock distributor with a brand new Summit Racing™ Vortec distributor and you'll get more power than you ever expected out of your ignition at a price that can't be beat. The distributors have heavy-duty features like a balanced rotor, aligned bronze oilite bushings for extended street use, and a cast aluminum housing that's machine-finished. They have a magnetic trigger for a consistent, powerful spark and a blue cap with brass terminals for excellent spark transfer. Each distributor is dynamically tested, so you can trust that you're getting a high-quality distributor.
( 162 )
$180.99
—
$214.99
How would you like to keep your engine running consistently throughout the entire rpm range? It's easier than you think when you swap out your old points distributor—for the hot spark and accurate timing of a Summit Racing™ Mopar electronic distributor. Equipped with a vacuum advance and performance advance curve, these distributors deliver rock-solid timing across the entire rpm range for outstanding performance. They come in a cast aluminum housing with a machined finish—and are available individually or in a kit. Order the model recommended for your vehicle. When it comes to high performance, Summit Racing™ delivers!
( 2 )
$140.99
—
$190.99
Modal Header
Truck / SUV
Jeep®
Restoration
Stock Replacement
Late Model Muscle
Tools
Gifts, Clothing, & More
Circle Track
Street Rod
Powersports
Paint & Body
Marine
Jr Dragster
