Availability
Showing In Stock Items. Show All 18 Items.
On Sale
Trail-Gear heavy-duty driveline kits will move you! The splines are 42 percent larger, and the spline section is nylon-coated to prolong many years of use on the trail. These kits come with a heavy-duty U-joint installed and full circle retaining rings to securely hold the U-joint in place. Whether you're on the track or trails, get things in motion with Trail-Gear heavy-duty driveline kits.
( 2 )
$399.99
$339.99
On Sale
Driveline too short after lifting your truck? Then you need one of these Longfield driveline spacers. Made from strong 6061-T6 billet aluminum and coated with a black anodized finish, these are extremely tough spacers. They are also quad-drilled for four popular Toyota driveline bolt patterns, making for an easy solution. Adjust your driveline and get back on the trail with Longfield driveline spacers.
( 2 )
$57.96
—
$60.72
$49.27
—
$51.61
On Sale
When it's time for a rebuild or to swap the transmission out for a 5-speed, Scott Drake slip yokes are the best bet for your Mustang. These yokes are specifically designed for your vehicle and will provide exceptional service. When it's time to rebuild or strengthen your yoke, go with the company synonymous with Ford--get Scott Drake slip yokes.
( 9 )
$149.95
$134.95
On Sale
Summit is proud to offer our Summit Racing™ Transmission Yokes. Built from quality materials these are offered in various Lengths and common U-joint sizes to allow you to replace your bent, rusted, or worn factory yoke or finish up a swap where the driveshaft is just a touch too short. Eliminate that last weak spot in your driveline with Summit Racing™ transmission yokes.
( 60 )
$258.99
$249.99
On Sale
Stock drive shaft U-joints aren't designed for rock climbing or other off-road tortures. When you need tough U-joints for crawling up and over rock ledges or through the deepest mud, use Trail-Gear Creepers. These heavy-duty joints are tested to 4,700 ft.-lbs. of torque due largely in part to additional material being added to the center section. Unlike other strong off-road joints, these are originally based on stock designs, making them better for all-around use than many other joints. They include a Zerk fitting and four installation clips. Trail-Gear Creeper U-joints have torque ratings around 1,000 ft.-lbs. higher than stock units, yet cost around the same. They're an incredible deal!
( 1 )
$39.99
$33.99
On Sale
Racepak magnetic pick-up collars provide a mounting platform for up to eight magnets. This allows them to pick up driveshaft rpm faster than typical 2-magnet designs. Simply mount them on your rear-end yoke or coupler, then set up your sensor. They're available in several popular diameter sizes, and are perfect for automatic-equipped vehicles. Increase your data gathering efficiency with Racepak magnetic pick-up collars.
Not Yet Reviewed
$139.95
$90.95
On Sale
U-joints act as a pivot point, allowing them to continue transmitting power even when at an angle, and Matsuba universal joints are the gold standard at which all other Toyota aftermarket joints are judged. Trail-Gear Matsuba U-joints are offered as OEM replacements for your stock or mildly modified vehicle or as an upgrade for those of you whose off-roading adventures would result in any type of joint snapping. Most universal joints include zerk grease fitting and all include C-clips. Toyota, Suzuki, and Chevy applications are available. Select the Trail-Gear U-joint designed for your vehicle.
( 3 )
$39.99
$33.99
On Sale
Wheeler's Off-Road Matsuba U-joints are the gold standard at which all other Toyota aftermarket joints are judged. The original supplier of the OEM U-joints that came on the Toyota pickup, they are strong but priced economically. Matsuba is a great choice for stock or mildly built Toyota Trucks and 4Runners.
Not Yet Reviewed
$39.85
$33.87
On Sale
Exploring off-road trails can be challenging, scenic, and highly pleasurable, but your vehicle's axles and driveshafts are constantly battling enemies intent on breaking them. Spicer Drivetrain Products performance driveshafts come ready for the onslaught, with shafts that are 50 percent thicker than stock and have a smaller diameter for increased clearances. These driveshafts are designed for vehicles with either short or medium lifts and have longer travel slip yokes. They are available either with or without a new transfer case yoke and hardware. Bending a driveshaft on the trail leads to all kinds of issues. For a heavier duty shaft, go with Spicer Drivetrain Products performance driveshafts.
( 3 )
$555.99
—
$848.99
$517.07
—
$764.09
On Sale
Hardware for your driveshaft--Trail-Gear bolts, nuts, and washers are the replacements you need. Providing the expected fit and function, these pieces are factory-level replacements. Make your driveshaft secure with Trail-Gear hardware.
( 1 )
$4.99
—
$5.99
$4.24
—
$5.09
On Sale
Longfield offers U-joint rebuild kits to maintain a variety of Dana applications. Designed to rebuild your Longfield 300M U-joints, these kits include U-joint caps with brass bushings pressed in, cap grease seals, and C-clip retaining rings for one joint.
Not Yet Reviewed
$114.11
$96.99
On Sale
Superlift Suspension driveshafts are made from the same high-quality materials as stock—and are direct replacements for OE shafts. However, there's an important difference. Where OE shafts have only two U-joints—one at each end—Superlift shafts have three. Two of them are paired up at one end, allowing them to take much greater "angles" than the stock units. That can be an important factor when you're lifting your vehicle. These driveshafts are available for a variety of applications from the 1990s and up.
( 5 )
$799.99
$679.99
On Sale
Quadboss center driveshaft bearings are more aggressive than the OEM seals, working better to keep dirt and water out of the bearings. They come as complete assemblies and are vehicle-specific. Choose the Quadboss bearings that best fit your utility vehicle.
Not Yet Reviewed
$67.89
$61.10
On Sale
Quadboss chain rollers are high-quality chain rollers designed to be direct OEM replacements. They feature triple lip sealed ball bearings that provide superior dirt exclusion compared to OEM bearings. Whether you're looking for an upgrade or replacement chain roller for your ATV, these Quadboss chain rollers are a perfect solution either way.
Not Yet Reviewed
$10.66
—
$24.24
$9.59
—
$21.82
On Sale
Quadboss universal joints feature a heavy-duty construction for increased static strength and longer life. Their precision-ground trunnion and bearing surfaces ensure trouble-free operation. Each Quadboss universal joint is manufactured for a perfect fit in every application!
Not Yet Reviewed
$27.15
—
$42.67
$24.44
—
$38.40
On Sale
Spicer Drivetrain Products one-piece aluminum driveshafts improve acceleration, eliminate flexing and annoying clunks, and reduce the rotating mass of factory 2-piece driveshafts. Constructed from 6061-T6 aluminum tubing for strength, these replacements are lighter so your car can accelerate faster with a smoother, quieter ride. Order the model recommended for your transmission application. Features include: * Reduced overall weight and rotating mass of the driveline * Eliminates the need for a center bearing * Direct bolt-in with no need for an adapter * Available in a variety of lengths and diameters * Larger diameters allow for higher rpm with less noise, vibration, and harshness * 0.125 in. wall thickness * Includes hardware
( 8 )
$848.99
$789.56
On Sale
Longfield U-joints are cross-drilled, which will give you more grease storage! Manufactured from superb 300M steel, they are fitted with high-impact aluminum nickel bronze bushings, which are better for high speed than standard bronze, and will help prevent galling. They are rebuildable and include full-circle C-clips. With one grease fitting instead of four, Longfield provides better U-joints for your Dana 30/44 and 60.
Not Yet Reviewed
$288.35
—
$326.03
$245.10
—
$277.13
On Sale
Spicer Drivetrain Products Extreme U-joints are specifically designed for adventure-seekers who put their vehicles through the most challenging trails. These super-strong steel U-joints are recommended for off-road use.
( 1 )
$693.59
$624.23
Modal Header
Truck / SUV
Jeep®
Restoration
Stock Replacement
Late Model Muscle
Tools
Gifts, Clothing, & More
Circle Track
Street Rod
Powersports
Paint & Body
Marine
Jr Dragster
