Availability
Showing In Stock Items. Show All 6 Items.
Activate and deactivate circuits at pre-programmed rpm "windows" with these Nitrous Express switches. They are especially useful for nitrous-equipped engines because the nitrous system can be shut down just before the engine's high-rev limit. They include a ground to activate a circuit and can handle up to 1.5 amps.
( 3 )
$253.85
NOS two-stage wide open throttle/rpm-activated window switches are a compact, user-friendly way to eliminate the need for replacing rpm pills every time you want to change the activation rpm of your nitrous kit. They take window switches to the next level, too, eliminating the need for two rpm-activated window switches to control your two stages of nitrous! NOS two-stage wide open throttle/rpm-activated window switches feature two fully programmable independent rpm window switches. They can operate from 0 to 20,000 rpm for anything from a low-rpm engine to a high-revving sport bike, and they are perfect for carbureted or EFI vehicles. Their capability to read a rising or falling throttle position sensor provides accurate activation--every time. A programmable output activates a shift light for on-time, gear-pounding shifts, and the recall feature shows max rpm and TPS voltage for easy setup. NOS two-stage wide open throttle/rpm-activated window switches have a bright, easy-to-read display and bright LEDs that light up when stages are active for easy activation verification. These versatile switches can be used for nitrous or to activate other accessories.
( 10 )
$299.95
MSD rpm-activated window switches allows you to take control of your nitrous. You can activate and deactivate circuits at pre-programmed rpm "windows" and they are especially useful for nitrous equipped engines, because the nitrous system can be shut down just before the engine's high-rev limit. They include a ground to activate a circuit, and can handle up to 1.5 amps.
( 26 )
$286.95
Dyna 2Ki Programmable Ignitions not only add to, but extend, many features of the Dyna 2000 modules with a completely new design that fits under the cam cover. Every time power to the ignition is switched on, the 2Ki checks to see if the coil is shorted, mis-wired, or of the wrong type. If an error is detected, the 2Ki will immediately switch off and issue a warning. After starting, the 2Ki continuously monitors the status of the coil and wiring. All 2Ki ignitions are PC programmable: * 8-point fully-definable wide-open throttle curve * 8-point fully-definable part-throttle curve * Rev limit programmable in 50 rpm steps * Programmable dead cranking revs 0-10 * Programmable rear cylinder offset, total of +/- 10 degrees Data recording functions: * Total engine hours * Time at wide-open throttle * Number of engine starts * Longest time operating at wide-open throttle * Maximum rpm * Seconds near rev limit * Statistical analysis of time at rpm Additional features and benefits include: * Single-fire operation down to zero rpm for easier cranking and kicking * Operates in all combinations of single-fire or dual-fire with single plug or dual plug heads (when used with appropriate coils) * Eight advance curves to cover a broad range of engine builds and riding styles * Over-rev protection adjustable from 6000 to 7500 rpm * Adjustable timing retard for nitrous and turbo applications * VOES indicator; shows the status of the VOES switch, also indicates when retard mode is active * Built-in tach driver delivers stable tach signal even during rev limiting; can be used to activate shift lights, auto shifters, and other accessories * Easy static timing with built-in timing indicator (no timing light required) * Intelligent over-current and short circuit protection * Active dwell control continually adjusts coil current to maintain maximum spark energy up to redline while eliminating coil stress caused by overcharging at idle * High-efficiency design reduces battery draw for easier cold weather starting and lower charging system load * Ruggedized output--cannot be damaged by broken or disconnected spark plug wires * Over-voltage protected against momentary spikes (positive and negative) as well as surges caused by faulty voltage regulators or quick-charge battery boosters * Harness constructed with TXL cross-linked polyethylene automotive wire for exceptional resistance to abrasion, heat, and chemical attack * High-temp glass-braid jacket further increases the toughness of the harness and provides a tight, clean appearance * Wire colors closely match the factory harness for error-free installation * Manufactured with premium-quality components designed for operation in a high-temperature, high-vibration environment * One-piece aluminum housing and thermally-conductive epoxy encapsulation provide superior heat dissipation and outstanding shock, vibration, and moisture resistance * Advanced microprocessor technology * Quartz crystal accuracy.
Not Yet Reviewed
$418.99
MSD Power Grid system controllers are the brains behind the entire Power Grid system, and they can be used with any MSD ignition or Pro Mag to provide advanced ignition tuning capabilities. While they're compatible with all MSD ignition boxes, they've been specially designed to mount on top of the Power Grid 7 ignition box. Features include: * USB connection for easy programming * Timing based on engine rpm and gear value * Advanced individual cylinder timing based on gear or time * Five retard stages for nitrous * Four steps of rpm limits for burnout, spool, launch, and overrev * Output switch set on rpm, pressure, or time * Shift light settings for each gear * Ignition data acquisition accepts multiple runs * View software * Wiring harness * Micro SD-card
( 10 )
$368.95
On Sale
Get on the performance grid with MSD Ignition Power Grid power modules. When connected to the Power Grid, they will data log all the functions--including time from launch and time or rpm of activation and deactivation. These timing controllers feature four high-current, solid-state switches that can be configured independently or in conjunction by time, rpm, and temperature switching on/off, as well as by percentage for nitrous systems. Each channel is capable of handling 20 amps of current without the use of a relay and can be used to activate fan, fuel pump, nitrous oxide system, throttle stop, and more--the possibilities are endless.
( 1 )
$749.95
$412.95
Modal Header
Truck / SUV
Jeep®
Restoration
Stock Replacement
Late Model Muscle
Tools
Gifts, Clothing, & More
Circle Track
Street Rod
Powersports
Paint & Body
Marine
Jr Dragster
