Availability
Showing In Stock Items. Show All 5 Items.
Add GM 6L80/90E transmission control to any existing vehicle utilizing a Terminator X Max ECU. A departure from traditional Holley EFI transmission control, the Terminator X Max ECU allows the ability to use 2007+ GM 6L80E and 6L90E transmissions by communicating via CAN with the internal TCM (Transmission Control Module). The supplied Holley EFI OBDII transmission tuning hand-held is used to adjust shift points, tire size and gear ratio. Terminator X V3 software provides the ability to dial in torque management to optimize the desired shifting characteristics when using a 6L80/90E transmission. The software also enables you to control the secondary shift mode within the transmission TCM and allows use of tap Up/Down shifting. Within Terminator X V3 PC Software: --- Virtual Torque Management Tables --- Virtual TPS Tables to dial in shift characteristics regardless of engine --- DBW and Timing torque reduction tables to create smooth shifts Within the Holley EFI OBDII Transmission Tuning Hand-held: --- Ability to read and clear TCM fault codes --- Ability to raise and lower shift points by MPH or RPM --- Support for Tap Up/Tap Down & Transmission's Secondary Shift Mode If you currently have a Terminator X ECU, upgrading to a Terminator X Max ECU can be easily done by plugging your main harness into the Max ECU and re uploading your existing calibration. Holley Terminator X MAX GM 6L80/90 transmission kit features: * Included TCM hand-held tuner with integrated wizard is required for setup in conjunction with the Terminator X 3.5 in. hand-held. Terminator X V3 software unlocks optional tuning parameters. * Plug-and-play with any engine controlled by a Terminator X Max ECU * Supports: Shift Mode - Tap Up / Tap Down, and torque management * Four loose wires: --- Power (Red): Supplies power to the transmission solenoids. This should be connected directly to the battery, or a constant battery source capable of supplying 5 amps --- Ground (Black): Connect to a good chassis/engine ground source --- Brake Switch (Light Blue/White): Wired to the brake light switch. This must be installed to a +12 V source (as most brake light switches are) --- Park/Neutral Safety (Yellow): Circuit for starter solenoid. When the transmission is in Park or Neutral, this yellow wire will be grounded (-). When the transmission is in gear this circuit will be open.
Not Yet Reviewed
$573.95
Superchips Pulsar XT Ford Bronco computer programmers control the following features: * Amber DRLs: This allows you to use the amber lights as your daytime running lights and turn signals. Stock, they are used only as turn signals. NOTE: DRLs will not be amber when your high beams or low beams are on. * Auto Start Stop Disable: Disables or enables the auto start/stop system on vehicles already equipped with it. * Battery Management System: Disables BMS. This will allow the battery to charge above the preset threshold. The vehicle will no longer warn you if your battery is getting low due to your headlights or radio being on. The side effect of disabling this system is the auto start stop system will also be disabled. * Dark Mode: Interior lights will remain off when the doors are opened. * Daytime Running Lights: Enable/disable DRLs * DTC Read/Clear: Feature will scan vehicle for Diagnostic Trouble Codes and report any found. Clear command will delete any present codes in the system * Emissions Readiness: This feature will check the current status of the vehicle's emissions readiness monitors. * Fog Lights with High Beams: Enables fog lights to stay on with high beams. * Headlamp Switch: The stock setting is for the vehicle to put the headlamp switch to "auto" when the vehicle is turned on. This will allow the vehicle to remember the previous setting after a key cycle. * Honk Warning: No longer honks if you leave the vehicle with the key if the engine is running. * Remote Start Duration: Change duration to 0, 5, 10, or 15 minutes. * Tire Size: Allows speedometer and odometer calibration for tire size changes up to 37 in. tall (36.25 in. measured). For most accurate results, measure tire height mounted on vehicle with a tape measure and input that reading, not what is printed on tire sidewall. * TPMS Adjust: Allows factory TPMS warning threshold to be adjusted between 1-99 psi. Use this feature if you want to run lower than factory tire pressure * TPMS Disable: This feature will completely turn off the TPMS system. Use when running below 25 psi or if tires are no longer equipped with TPMS sensors.
( 1 )
$671.95
Crank up the power with Roush 2015-17 Mustang GT Level 1 Performance Pacs. These assemblies can increase rear wheel power by 25 hp and 30 lb.-ft. on your stock Mustang GT 5.0L V8. They include Roush CAD-designed and tooled cold air kits that are fully tested and calibration-certified to work seamlessly with their performance ECU re-flash, while adding a sporty sound to your engine. Level 1 Pacs will maximize your underhood space, and the premium automotive-grade, injection-molded material will last a long time. Plus, with a lower intake restriction over stock, you'll never need to upgrade your intake, no matter what mods you plan in the future. Let the experienced engineers from Roush handle the details—you'll get improved horsepower and torque, along with aggressive throttle mapping, a sporty feel, and strong performance without sacrificing drivability. Simply install a Mustang GT Level 1 Performance Pac!
Not Yet Reviewed
$749.99
Modal Header
Truck / SUV
Jeep®
Restoration
Stock Replacement
Late Model Muscle
Tools
Gifts, Clothing, & More
Circle Track
Street Rod
Powersports
Paint & Body
Marine
Jr Dragster
