In-Store Pickup Location Close

Melling Engine Priming Tools PT11

$30.97

Oil Pump Primer, Ford, Small Block/Big Block FE, Each

Estimated Ship Date: Today Would you rather pick it up? Select Location

Brand: Melling
Manufacturer's Part Number: PT11
Part Type: Oil Pump Primers
Summit Racing Part Number: MEL-PT11

Quantity: Sold individually.
Notes: 1/4 in. hex drive.
In-Store Pickup: Choose In-store pick-up (OH, GA, NV) on our web site.

Melling engine priming tools are specialty tools that help prevent galling. Manufactured from the highest quality materials available, Melling engine priming tools circulate oil through critical areas of your new engine before engine startup.

Warranty

Most Helpful Reviews Review this Product

2 Customer Reviews for Melling PT11 - Melling Engine Priming Tools

Average Customer Review

5 Star

(1)

4 Star

(1)

3 Star

(0)

2 Star

(0)

1 Star

(0)
+See All 2 Reviews

Priming tool for Ford Big Block FE

Summit RacingSummit Racing Verified Purchase

I'm building a 427 Fe with a Blue Thunder intake manifold. I purchased the Melling oil priming tool and it arrived within a few days. It's sturdy, well made and fit the oil pump shaft correctly. The only problem I had was the shaft of the priming tool slides all the way through the support disk and the diameter of the disk is smaller than the intake. This allows the support disk to fall into the valley where it stop at the smaller diameter hole in the block. However, when you pull the shaft back out the disk remains inside. I put a few wraps of electrical tape around the lower part of the shaft which kept the disk on the shaft and I was able to pull it out. It primed the engine perfectly and I even found a small oil leak in a rear oil galley plug above the crank. Needless to say I was very pleased I purchased this tool. ...read more

0 of 0 found this review helpful.

report abuse

Report Abuse Close

If you feel that this review is inappropriate and should be removed from the site, report it to us by clicking the "Report Abuse" button below.

Cancel

Reviewer: KIM from AZ

Date: March 19, 2014

Appearance
Ease of Installation
Price/Value
Quality

Safe method to pre-oil

Summit RacingSummit Racing Verified Purchase

I like the extension stabilizer that fits into the engine block distributor hole to stabilize the melling shaft when turning the oil pump. This minimizes possible damage to original oil pump shaft. (although, to be on the safe side, I did replace that rod after priming the engine.)

0 of 0 found this review helpful.

report abuse

Report Abuse Close

If you feel that this review is inappropriate and should be removed from the site, report it to us by clicking the "Report Abuse" button below.

Cancel

Reviewer: MITCHELL from MA

Date: March 02, 2014

Appearance
Ease of Installation
Price/Value
Quality

Some parts are not legal for sale or use in California on any pollution-controlled motor vehicles

Back To Results
Email this page Close
Close